Monaco DYNASTY 2006, User Manual

Page: 132 / 384

132 • SECTION 4 — APPLIANCES DYNASTY 2006
Care & Cleaning
The exterior of the microwave/convection oven is plastic and metal. The interior is metal. Do not clean with
scouring pads, harsh or abrasive cleaners, chemical cleaners or petroleum based thinners that can damage the
fi nish. Use mild soap and water with a damp cloth or paper towel to remove stains or spills. When cleaning the
touch pad, open the door to prevent accidental operation. Use mild soap and water with a soft cloth. Avoid using
excess amounts of water on the touch pad. The turntable plate and oven racks are dishwasher safe.
Charcoal Filter:
Depending on use the charcoal fi lter should be replaced every 6 to 12 months. Use the following procedure to
remove the louvers to replace the charcoal fi lter and oven light.
1. Remove power to the microwave/
convection oven.
2. Remove the screws
(A)
securing the louver.
3. Insert a fl at edge screwdriver over each tab
pressing downward and move the louver
away from the microwave.
4. Remove and replace the charcoal fi lter.
Ensure the fi lter is positioned on the
supporting tabs.
5. Replace louver and mounting screws.
Oven Light:
1. Remove the louver as indicated above.
2. Slide the metal light cover forward and lift upwards.
3. Remove the light bulb and replace only with an equivalent watt bulb.
DO NOT EXCEED 30 WATTS.
4. Replace light cover, louver and mounting screws.
Hood Light:
1. Remove power to the microwave/convection oven.
2. Remove the screw
(B)
securing the light cover.
3. Remove the light bulb and replace only with an equivalent watt bulb.
DO NOT EXCEED 30 WATTS
.
4. Close the cover and re-secure with screw.
CAUTION:
Light cover may be hot. Do not touch glass with lamp ON. Never use the light for prolonged
periods, such as a night light.
Grease Filters:
Operating the microwave/convection oven without the grease fi lters in place can damage the unit. Grease fi lters
should be cleaned at least once a month. To remove the fi lters, use the pull-tab to slide the fi lter to the end of the
opening and tip down. Soak the fi lters in the sink or in a dishpan fi lled with hot water and detergent.
• Do not use ammonia or other alkali-based products that may darken the fi lter material.
• Agitate the fi lter. Use a scrub brush to remove caked on grease.
• Rinse the fi lter thoroughly and shake dry. Place the fi lter back into the opening, tip upward and slide fi lter
to the end of the opening. Lock in place. Be careful not to kink or warp the fi lter upon installation.
031106c