Monaco DYNASTY 2006, User Manual

Page: 138 / 384

138 • SECTION 4 — APPLIANCES DYNASTY 2006
Aux Heat Mode:
If the Heat Pump mode is selected at or below 30° F, or if operating in Heat
Pump mode and temperature drops to 30º F, the air conditioner will stop Heat
Pump operation and Aux Heat will be displayed. The Aqua-Hot will be selected as
the auxiliary heat source and will begin operation. The Aqua-Hot will remain the
primary heat source until ambient temperature rises above 42º F.
When ambient temperature is between 30 and 42º F, a defrost cycle is initiated
approximately every 40 minutes of compressor operation. The blower motor will
stop for fi ve minutes and Defrost will be displayed. After the defrost cycle the heat
pump operation will resume.
NOTE:
The Aqua-Hot needs to be on for the Aux Heat to function. Turn
on the Aqua-Hot diesel burner or electric element. The exchanger
blowers automatically begin operation in the Auxiliary Heat mode.
Heat Pump Operation:
• Turn
ON
the interior house power.
• Slide the
ON/OFF
switch to the
ON
position.
• Press the
MODE
button repeatedly until
Heat Pump
is displayed.
• Set desired fan speed by pressing the
FAN
button.
• Press the
UP
or
DOWN
buttons to set desired heating temperature.
Return Air Filters
Frequently clean the return air fi lters. The fi lters are located inside the A/C behind
the intake vent covers. The bedroom cover hinges at the rear with catches at the front.
Grasp the leading edge and pull down to open. The living room fi lter is accessed by
lowering the decorative ceiling panel. To lower the panel, use a ratchet and a 7/16”
socket with an extension. Remove bolts on the road side and gently lower panel. The
panel is hinged on the curb side. The fi lters are secured in place with screws. Operating
the air conditioner without the return air fi lters in place may plug the evaporator core
with dirt and substantially affect the performance of the air conditioner.
NOTE:
To prevent scratching the mirrored surface when accessing filters, place
a protective barrier, such as a cotton towel, between the mirrored surface
and work area of any tools.
To Clean the Return Air Filters:
• Wash fi lters in warm soapy water. Do not use solvents.
• Rinse fi lters thoroughly with fresh water. Allow them to dry.
• Install fi lters and secure the intake vent covers.
050200b
HEAT
PUMP
Closed Position
Open Position
070192b
Bedroom A/C Filter
Access