Monaco DYNASTY 2006, User Manual

Page: 142 / 384

142 • SECTION 4 — APPLIANCES DYNASTY 2006
Heating Water with 120 Volt AC:
• Have either shore power (preferred) or the generator supplying AC voltage.
• Press the water heater switch. The indicator lamp will glow steady.
NOTE:
It is not fuel efficient to use the generator to operate the water
heater on 120 Volt AC.
Heating Water with LP-Gas:
• Make sure the LP-Gas is turned on.
• Press the LP-Gas water heater switch. The indicator lamp will glow steady.
A fl ashing lamp will indicate lockout. Press the switch twice to reset the
ignition cycle.
NOTE:
LP-Gas and 120 Volt AC functions can be on at the same time. This will speed up the process
of heating water for large volume use.
CAUTION:
It is recommended not to operate the water heater on LP-Gas while the motorhome is in
transit. Be sure the water heater is off before refueling.
NOTE:
Due to potential air in the LP-Gas lines, the water heater will attempt three ignition cycles.
If the burner does not light after the third attempt, the LP-Gas function will “lock-out.”
Reasons for lockout may be air in the gas system or burner tube obstructions caused by an
insect or spider web.
High-Temperature Thermostat:
Separate thermostats are used for LP-Gas and AC electric. If a thermostat fails, a high-temperature safety limit
switch will open.
CAUTION:
If the high-temperature safety limit should open, discontinue using
the water heater. Have the water heater inspected by a qualified
technician to determine the cause of the over temperature condition.
Water Heater Bypass Valve:
The bypass valve is located at the back of the water heater. Turning the valve to
the bypass position prevents water from entering the water heater. Turn the valve to
the bypass position when winterizing. For normal operation, turn bypass valve to
normal fl ow.
Water Heater
Bypass Valve
040581b
060297e