Monaco DYNASTY 2006, User Manual

Page: 217 / 384

DYNASTY 2006 WATER SYSTEMS — SECTION 6 • 217
To turn the water pump on or off:
• Momentarily press the water pump switch. The yellow
indicator lamp on the interior switch, or the green LED on
the service center switch, will illuminate when the water
pump is turned on.
CAUTION:
Do not continue water pump operation if the fresh
water holding tank is empty. Damage to the water
pump or electrical supply system may result.
To operate the water pump after unhooking from a city water supply or after storage:
• Close all drain valves and low point drains.
• Fill the fresh water tank.
• Open the hot and cold water valves of each faucet.
• Turn the water pump on. Wait for the water lines and
the hot water tank to fi ll.
• Close each faucet when it delivers a steady stream of
water (cold water faucets fi rst).
Water Pump Troubleshooting
Vibration induced by road conditions can cause the plumbing or pump hardware to loosen. Check the water
pump system for components that are loose. Many symptoms can be resolved by tightening the hardware. Check
the following items:
Water pump will not start or blows the fuse:
• Check the electrical connections, fuse or breaker, main switch and ground connection.
• Is voltage present at the pressure switch on the pump? If voltage is present, the pressure switch may be
faulty. As a test, temporarily bypass the pressure switch.
• Check the charging system for correct voltage and good ground.
• Check for an open or grounded circuit or motor.
• Check for a seized or locked diaphragm assembly (water frozen).
WATER
PUMP
Service Center
Water Pump Switch
080335c
Interior Water
Pump Switch
060297d
WATER
PUMP
Clean inlet screen every 60 days.
040547
040445d
Water Pump