Monaco DYNASTY 2006, User Manual

Page: 171 / 384

DYNASTY 2006 EQUIPMENT — SECTION 5 • 171
Manual Override
If the slide room does not operate, a safety feature may be engaged to prevent room operation.
If the slide room does not respond from the switch:
• Is the ignition key OFF?
• Is the park brake applied?
If the slide room does not operate after checking the safety requirements:
• Ensure all electrical connections at the switch are good.
• Ensure fuse is good, the house batteries are fully charged and the battery cut-off is on.
If the pump motor operates but the room does not move:
• Check the two fuses adjacent to the hydraulic pump. If the fuses test good and the room does not operate,
it is possible to manually retract the slide. Dual galley slide rooms use different hydraulic components.
Several people (as many as eight) are needed to push in the room.
• It may be necessary to contact a repair facility to have the problem diagnosed and repaired.
To move the slide room manually:
1. Access the slide room hydraulic pump in generator compartment (curbside) at front of the motorhome
behind the fi rewall.
2. Use the ¼” nut driver on the end of the reservoir cap to turn the release nuts on the solenoids
counterclockwise. Do not exceed 4 ½ revolutions. Damage to the solenoids may result. The room may
move slightly when valves are opened and internal pressure is released.
3. Line up an equal distance along the outside wall. Do not push on the fl ange.
4. In synchronized movements, push the room in with repeated attempts.
5. Close the release nuts when the room is fully retracted.
NOTE:
The slide room is heavy and will require several people to push into position. When the
slide room is fully retracted, tighten the release nuts to hold the room in place. Do not over-
tighten.
090342h