30
D
ESK
T
OP
S
ERIES
–
AUTOMATIC OPERATION
4.3.2
DT-370 systems
The adjustments of the Bond head are done in accordance with the applicable manual:
69H0082 (80N0 or 69H0504 (500N).
The height adjustment is set before shipment. If the customer supplies a product support, the
necessary settings are made and the results recorded. If no product support is provided, the
thermode height is set at approximately 40mm above the base plate.
The left and right position adjustment is done before shipment. However, Miyachi trained
persons can do small adjustments according to the customer’s settings. Do the steps that
follow to adjust the left/right positions.
The illustrations that follow show the manual version. The adjustment procedures are the
same for the pneumatic version.
1.
Sensor long cylinder in
2.
Sensor long cylinder out
3.
Sensor short cylinder in
4.
Micro switch short cylinder out (start head)