54
D
ESK
T
OP
S
ERIES
–
AUTOMATIC OPERATION
6
GENERAL OPERATION OF THE DESKTOP SYSTEM
NOTE:
The detailed operation is customer dependent
The Desktop system is operated in combination with a two-hand control.
1.
Make sure the air supply is set to on.
2.
If applicable, set the vacuum supply to on.
3.
On all systems, raise the Uniflow power source main switch to the on position.
4.
On constant heat systems, set the main switch at the rear of the desktop to on. Make
sure the correct temperature for the product cycle is set.
5.
Make sure the emergency stop is deactivated. If it is not, turn it counter-clockwise to
deactivate it.
6.
Clean the parts to be connected.
7.
Position the parts to be connected on the fixture block. Make sure they are correctly
aligned with the thermode.
8.
Press the two-hand control to start the bonding cycle.
9.
After the bonding cycle is completed, remove the finished product.
10.
Do steps 4 thru 7 for the next product.
11.
When production is completed, press the emergency stop button (D, figure 9).
12.
Lower the Uniflow power source main switch to the off position
13.
Set the air pressure supply to off.
14.
If applicable, set the vacuum supply to off.
7
MAINTENANCE AND REPAIR
7.1
ADJUSTMENTS
These are described in the related manuals, but force and speed adjustments can be done by a
qualified operator.
7.2
PREVENTIVE MAINTENANCE
It is essential for high level performance of the system to do regular maintenance in
accordance with the manufacturer’s instructions. This will prevent unplanned downtime.
CAUTION:
Do not replace parts yourself but contact a qualified technician
