Mitsubishi 1992 3000GT, Service Manual

Page: 612 / 1308

AUTOMATIC TRANSAXLE
Troubleshooting
Diagnostic result indication by voltmeter
Example of diagnostic trouble code output voltage waveform
Waveform for diagnostic trouble code No.
Waveform when normal
digit
signal
delimiter digit
2 sec. signal
NOTE
Other diagnostic items are also indicated by the voltage waveforms corresponding to the code numbers obtainea
when the scan tool is used.
METHOD OF ERASE THE DIAGNOSTIC TROUBLE CODES
When using the scan tool [Multi-use tester (MUT) to 1993 model> or MUT-II
models>]
(1) Turn the ignition switch to OFF and then back to ON again.
(2) Erase the diagnostic trouble codes.
(3) Check to be sure that no diagnostic trouble codes exist.
When using the voltmeter
- -
(1) Turn the ignition switch to the OFF.
(2) After disconnecting the battery cable from the battery
terminal for seconds or more, reconnect
the cable.
(3) Turn the ignition switch to the ON, and read the diagnostic trouble codes to check that a normal
code is output.
TSB Revision