Mitsubishi 1992 3000GT, Service Manual

Page: 648 / 1308

Lock cam A
W
I A
Look cam A
W a
Lock cam A
Reverse (R) position
alarm buzzer
(7) Connect the key interlock cable to lock cam A and
temporarily tighten the nut.
At this time, install the spring and washer, which have
been fitted to the key interlock cable, as shown.
(8) Lightly pressing cam A in the direction of arrow,
lightly push the key interlock cable to take up slack and
tighten the nut to secure the key interlock cable in position.
(9) Turn the set lever and fit it onto the fixing pin on lock
cam A, then install the snap pin.
the key interlock cable has been connected, check
the shift lock and key interlock mechanism. (Refer to
52.)
AUTOMATIC TRANSAXLE
Transaxle Control
KEY INTERLOCK CABLE CONNECTION
(SELECTOR LEVER ASSEMBLY SIDE)
(1) Place the selector lever into position.
(2) Connect the key interlock cable to lock cam A and
temporarily tighten the nut.
At this time, install the spring and washer, which have
,
been fitted to the key interlock cable, as shown.
(3) Lightly pressing lock cam A in the direction of arrow,
lightly push the key interlock cable to take up slack and
tighten the nut to secure the key interlock cable in position.
(4) Turn the set lever and fit it onto the fixing pin on lock
cam A, then install the snap pin.
(5) After the key interlock cable has been connected, check
the key interlock mechanism. (Refer to
INSPECTION
l
Check the control cable for function and for damage.
Check the outer cable (key interlock cable, shift lock cable)
for damage and spring for breakage and tension.
l
Check the inner cable (key interlock cable, shift lock cable)
for extension.
REVERSE (R) POSITION ALARM BUZZER CHECK
Check that the buzzer sounds when battery voltage is applied
across terminals.
TSB Revision