Mitsubishi 1992 3000GT, Service Manual

Page: 803 / 1308

REAR SUSPENSION
Stabilizer Bar
STABILIZER BAR BRACKET INSTALLATION
(1) Align the bushing (L.H.) with the stabilizer bar marking
end and temporarily tighten the stabilizer bar bracket
(L.H.).
(2) In this condition, mount the stabilizer bar bracket (R.H.)
and temporarily tighten it.
(3) Temporarily fix the both ends of the stabilizer bar to the
link and tighten the stabilizer bar bracket mounting bolts
to specification.
INSPECTION
l
Check the bushing for wear and deterioration.
l
Check the stabilizer bar for deterioration or damage.
l
Check the stabilizer link ball joint dust cover for cracks.
l
Check all bolts for condition and straightness.
STABILIZER LINK BALL JOINT BREAKAWAY TORQUE
CHECKING
Using the special tool, measure the ball joint breakaway
torque.
Standard value: 1.7-3.2 Nm (15-28
BALL JOINT DUST COVER REPLACEMENT
(1) Remove the clip ring and the dust cover.
(2) Apply multipurpose grease to the lip and inside of the
dust cover.
(3) Use vinyl tape to tape the stabilizer link where shown
in the illustration, and then install the dust cover to the
stabilizer link.
(4) Secure the dust cover by the clip ring.
TSB Revision