Mitsubishi 1992 3000GT, Service Manual

Page: 1021 / 1308

BODY
On-vehicle Service
Stabilizer
inner front
Window end Weatherstrip holder
I
Weatherstrip
00002235
4. Tighten the stabilizer inner front so that it presses against
the glass guide slider of the window glass assembly.
5. Tighten the up stop so that it presses against the glass
stop of the window glass assembly.
6. Tighten the stabilizer inner rear so that it presses against
the window glass assembly.
7. Check that the clearance between the weatherstrip holder
and the top edge of the window glass is as shown in
the illustration when the top edge of the window glass
is touching the weatherstrip.
8. Check that the relative position of the window glass end
the lip end of the delta sash is as shown in the illustration.
9. If the clearance or the position is not at the standard
values, repeat the procedures in steps 4 and 5.
TSB Revision