Mitsubishi 1992 3000GT, Service Manual

Page: 656 / 1308

AUTOMATIC TRANSAXLE
Transaxle Assemblv
bracket installation
(2) Remove the nut and move the bolt so that a spanner
can be applied to the transaxle mount bracket mounting
bolt; then, remove the transaxle mount bracket mounting
bolt.
ROD END LOWER ARM BALL JOINT
DISCONNECTION
Refer to GROUP 22 Manual Transaxle.
SHAFT (LEFT SIDE) AND INNER SHAFT
ASSEMBLY DRIVE SHAFT (RIGHT SIDE)
REMOVAL
Refer to GROUP 22 Manual Transaxle.
SPECIAL BOLTS TRANSAXLE ASSEMBLY
LOWER PART COUPLING BOLT TRANSAXLE
ASSEMBLY REMOVAL
(1) Support the transaxle assembly with the transaxle jack.
(2) Rotating the crankshaft, remove the special bolts at four
places.
(3) After removing the special bolts, push the torque converter
toward transaxle so that it does not remain on the engine
side.
(4) Remove coupling bolt at the bottom of transaxle assembly
and lower the transaxle assembly.
INSTALLATION SERVICE POINTS
TRANSAXLE ASSEMBLY INSTALLATION
Attach the torque converter on the transaxle side and mount
the transaxle assembly on the engine.
Caution
If the torque converter is mounted first on the engine,
the oil seal on the transaxle side may be damaged.
Therefore, be sure to first assemble the torque converter
on the transaxle side.
DRIVE SHAFT INSTALLATION (RIGHT SIDE)
Refer to GROUP 22 Manual Transaxle.
TRANSAXLE CONTROL CABLE CONNECTION
(1) Connect the transaxle control cable to the manual control
lever and tighten the nut temporarily.
(2) Loosen the nut, pull the transaxle control cable lightly
in the arrow direction and retighten the nut.
TSB Revision