Mitsubishi 1992 3000GT, Service Manual

Page: 647 / 1308

AUTOMATIC TRANSAXLE Transaxle Control
Set lever
Fixing pin
INSTALLATION SERVICE POINTS
LOCK CABLE CONNECTION (BRAKE
PEDAL SIDE)
Connect the shift lock cable so that its threads measure about
4 mm
in.).
Caution
Do not change the routing of shift lock cable to the selector
lever assembly.
LEVER KEY INTERLOCK CABLE
(STEERING LOCK ASSEMBLY SIDE) CAM
LEVER INSTALLATION
(1) Place the ignition key at the “LOCK” position or keep
it removed.
(2) Install the slide lever, key interlock cable, and cam lever
to the steering lock assembly as shown.
Caution
Do not change the routing of key interlock cable to
the selector lever assembly.
TRANSAXLE CONTROL CABLE CONNECTION
(SELECTOR LEVER ASSEMBLY SIDE)
Connect the transaxle control cable, then make the following
adjustment.
(1) Place the selector lever in
position.
(2) Loosen the nut and slightly pull the transaxle control cable
in the direction of the arrow; then, tighten the nut.
LOCK CABLE CONNECTION (SELECTOR
LEVER ASSEMBLY SIDE)
(1) Place the selector lever in position.
(2) Disconnect the key interlock cable from the selector lever
assembly side.
(3) Turn the lock cam B counterclockwise (arrow (1)) to move
the set lever upward (arrow (2)).
(4) Fit the cutout in set lever to the lock pin of lock cam
B.
(5) Connect the shift lock cable to lock cam B and temporarily
tighten the nut.
At this time, install the spring and washer, which have
been fitted to the shift lock cable, as shown.
(6) Pressing the set lever to prevent lock cam B from moving,
lightly pull the shift lock cable to take up slack and tighten
the nut to secure the shift lock cable into position.
NOTE
Make sure that the shift lock cable end is in contact with
the fixing pin of lock cam B as shown, then install the
washer and snap pin.
TSB Revision