Mitsubishi 1992 3000GT, Service Manual

Page: 1037 / 1308

BODY Windshield
42-31
without sun roof>
Windshield moulding
<Vehicles with sun roof>
12
Windshield moulding
Section
Section
mm (in.)
Glass surface
l
2: Body surface
INSTALLATION SERVICE POINTS
SPACER (LOWER) WINDOW SPACER
(UPPER) WINDSHIELD GLASS WINDSHIELD
INSTALLATION
(1) vehicles without sun roof>
Install the windshield moulding to the windshield.
<On vehicles with sun roof>
Affix the window spacer (upper) to the specified area
of the windshield.
(2) Affix the window spacer (lower) to the specified area of
the windshield.
(3) When replacing glass, fit a new glass once to the body
and put matchmarks on the body and glass.
(4) Apply a uniform coat of primer to the illustrated areas
of the body and glass making sure it is applied without
breaks or thin spots.
Adhesive:
3M SUPER FAST URETHAN PRIMER 8608 or
equivalent
Caution
1.
The primer is used to strengthen bonding power.
Make sure that it covers the surfaces completely.
Note that the primer if applied to thick can cause
loss of bonding power.
2. Never touch the primer coated surface.
(5) Allow 3 to 30 minutes to dry the primer.
TSB Revision