Mitsubishi 1992 3000GT, Service Manual

Page: 712 / 1308

REAR AXLE
Drive
Shaft
REMOVAL SERVICE POINT
DRIVE SHAFT REMOVAL
Using a tire lever, etc. remove the drive shaft from the
differential carrier.
MB991380
I
band
Two-part serration
INSTALLATION SERVICE POINTS
OIL SEAL INSTALLATION
(1) If the oil seal is to be replaced because of damage, drive
it in by using the special tool.
(2) Apply the specified grease to the oil seal
DRIVE SHAFT INSTALLATION
Caution
1.
Be cautious to ensure that the differential carrier oil
seal is not damaged by the drive shaft
2. The right drive shaft for models equipped with the
LSD having a VCU has a two-part serration. Be very
careful to install each one on the correct side.
NOTE
The left and right drive shafts can also be distinguished
from each other by the identification color of boot band
(B.J. side).
Boot band (B.J. side)
identification color
Drive shaft (LH)
Drive shaft (RH)
White
Blue
Caution
Be sure to thoroughly remove any oil or grease, etc. from
the threaded part of the bolt and nut used for installation
to the companion flange, because any oil, grease, etc.
on these parts might cause later loosening even though
tightening is at the specified torque.
INSPECTION
l
Check the drive shaft boots for damage or deterioration.
l
Check the ball joints for excessive play or check operation.
l
Check the drive shaft spline for wear or damage.
TSB Revision