Mitsubishi 1992 3000GT, Service Manual

Page: 1022 / 1308

BODY
On-vehicle Service
Quarter panel
Larger
dimension
dimension
00002236
10. Turn the adjusting bolts of the glass guide rear track
and the glass guide front track to adjust so that the corner
of the window glass touches the, weatherstrip when the
door is opened by the amount shown in the illustration.
11. Install the door trim and the waterproof film. (Refer to
12. Open and close the door and move up and down the
window glass to check fitting of the door.
DOOR INSIDE HANDLE PLAY CHECK
1. Check that the door inside handle play is as specified.
Standard value
A (play): 7 mm in.)
B (OPEN): 46 9 mm (1.81 in.)
C (FULL): 69 mm (2.72 in.)
2. If out of specifications, adjust as described below.
1) Remove the door trim. (Refer to
2) Loosen the screw attaching the inside handle and
slide the inside handle back and forth to adjust the
inside handle play.
FLOOR PAN CHECK
A common result of body leaks is a soaked floor mat pad
or carpet, and it’s not unusual to find that the water is getting
in through the floor pan to some other low point in the body.
It is possible however, for water to enter higher up and run
downward to soak the mat.
Since a soaked mat should be removed for drying, it’s a
good way to start your check. Of course, mat removal means
you’ll have to take off door sill plates and pull out seats or
seat cushion. But, this gives you a clear field for action so
you can check body seam sealing and the plugs in the floor
pan.
TSB Revision