Mitsubishi 1992 3000GT, Service Manual

Page: 639 / 1308

AUTOMATIC TRANSAXLE
On-vehicle Service
4992
B
<From 1993
(7) Check that an O-ring is fitted at the location shown on
top of valve body.
(8) Replace O-ring of solenoid valve intermediate grommet
with a new one and then fit the O-ring into case.
(9) Install valve body and oil temperature sensor.
Bolt A Length 18 mm in.)
Bolt B Length 25 mm in.)
Bolt C Length 40 mm (1.57 in.)
Caution
Secure solenoid valve and oil temperature sensor
harness at locations shown. Especially the pressure
control solenoid valve (PCSV) harness must be routed
and clamped as shown in the illustration since it is
separated from other harnesses. Failure to secure
the harness results in its contact with the detent plate
or parking rod.
oil filter.
(11) Install new oil pan gasket and oil pan.
(12)Add the specified amount of ATF.
(13)Carry out hydraulic test. Readjust as necessary.
TSB Revision