Mitsubishi Electric PUHY-P250YJM-A, Service Manual

Page: 186 / 272

[
X
Troubleshooting ]
- 177 -
HWE10190 GB
In the case of MA remote controller
2. Phenomena
When the remote controller operation SW is turned on, the operation status briefly appears on the display, then it goes off,
and the display lights out immediately, and the unit stops.
(1) Cause
1) The power for the M-NET transmission line is not supplied from the outdoor unit.
2) Short circuit of the transmission line.
3) Incorrect wiring of the M-NETtransmission line on the outdoorunit.
Œ
Disconnected wire for the MA remote controller or disconnected line to the terminal block.
ΠThe indoor transmission line is connected incorrectly to the transmission terminal block for centralized controller (TB7).
ΠThe male power supply connectors on the multiple outdoor units are connected to the female power supply switch connector
(CN40).
In the system to which the power supply unit for transmission lines is connected, the male power supply connector is connect-
ed to the female power supply switch connector (CN40) on the outdoor unit.
4) Disconnected M-NET transmission line on the indoor unit side.
5) Disconnected wire between the terminal block for M-NET line (TB5) of the indoor unit and the indoor unit board (CN2M) or
disconnected connector.
(2) Check method and remedy
1) When 2) and 3) above apply, check code 7102 will be displayed on the self-diagnosis LED.
See Section X [4] -7- (2) Troubleshooting transmission power circuit of outdoor unit for how to check the items in Section 1 in the
flowchart above.(page 210)
YES
YES
YES
YES
NO
NO
NO
NO
Same symptom for all units in a
system with one outdoor unit?
Check the
self-diagnosis LED
Check 1).
Check for
2) and 3).
Check 4).
Measure voltages of the
terminal block for transmission
line (TB5) on the indoor unit.
17 - 30V?
Check 5).
Error found?
Indoor unit board or
MA remote controller failure
Correct
the error.
Correct the error.
Is the error code 7102
displayed?
0000002115.book 177 ページ ２０１１年６月４日 土曜日 午前１０時４８分