Mitsubishi Electric Melsec WS Series, User Manual

Page: 40 / 142

MELSEC-WS
Ethernet interface module
37
Parameter Length Value
Command WORD 00E1
H
= Auto update control
Request data set 1 WORD 0 = Do not send data set 1.
1 = Send data set 1.
Request data set 2 WORD 0 = Do not send data set 2.
1 = Send data set 2.
Request data set 3 WORD 0 = Do not send data set 3.
1 = Send data set 3.
Request data set 4 WORD 0 = Do not send data set 4.
1 = Send data set 4.
Auto update mode
update rate WORD 0 = Disable auto update messages.
Non-zero = Enable auto update message at
specified rate in ms. (If the value is 40 or
less, data sets are sent at 40ms
interval.)
Minimum = 40 ms, Maximum = 65535 ms
Auto update is disabled if all Request Input Data Set flags are set to zero.
The response message returned to the application by the Ethernet interface module:
Parameter Length Value
Command WORD 001E
H
= Response to the auto update control message
Configuration via Setting and Monitoring Tool
In order to configure the auto update mode of the Ethernet interface module via the
Setting and Monitoring Tool, perform the following steps:

Open the Setting and Monitoring Tool and load the hardware configuration
including the Ethernet interface module.

Click on the GETH Network module [13] button ( Network Modules button
when two network modules are used) above the main window and select the
desired network module or double click on the desired network module in the
hardware configuration view to open the network module configuration dialog.

Click on TCP/IP configuration on the left hand menu. The following dialog
appears:
Table 10:
Auto update mode
configuration command
Note
Table 11:
Auto update mode
configuration response