Technician’s Handbook
90
4. Verify that the telephone’s message waiting lamp is lit.
n
If the lamp is not lit, check the PMS-related logs in Maintenance. The
logs will indicate which section of the PMS message is invalid.
5. Type the PMS message required to turn off the telephone’s
message waiting lamp.
6. Verify that the telephone’s message waiting lamp is off.
Turning a telephone’s message waiting lamp on and off from a PC
confirms that the PBX’s PMS interface works correctly.
If problems continue when you reconnect the customer’s PMS
computer, check the maintenance logs for PMS related information,
identifying problems with the customer’s PMS hardware/software.
For the PMS to light a lamp station the Dial 0 for that tenant must be
a console, and the Dial 0 must be the same for Night 1 and Night 2.
Faster PMS PCs may have to be forced to wait for a reply from the
PBX.
^B M
W
space
1
space
x
x
x
x
^C
Start
Transac-
tion STX
(CTRL B
)
End
Transac-
tion ETX
(CTRL C)
Function
Code
Status
Code
1 = ON
0 = OFF
Station’s Extension
(Room) Number
Enter the telephone’s extension
number (5 digits with leading
spaces).
x
Summary of Contents for SX-200 EL
