Introduction
7
Introduc
tion
Connectivity from the Main Control Cabinet
The following cards with an interface module connect the main control
cabinet to the peripheral bays. The Control FIM Carrier cards support
fiber connectivity.The Control Triple CIM card and the PRI card support
copper and fiber connectivity.
n
Control Dual FIM Carrier card - allows the fiber connection of up to
two peripheral bays
n
Control Triple FIM Carrier card - allows the fiber connection of up to
three peripheral bays
n
Control Triple CIM card - allows the copper connection of up to three
peripheral bays; a copper connection may be substituted with a fiber
connection
n
PRI card - allows the fiber or copper connection of one peripheral
bay
You can have either
two
or
three
links to each peripheral bay:
n
With a MCC IIIEL / ELx control card, the Control Dual FIM Carrier
card provides three links per peripheral bay
n
With a MCC IIIEL control card, the Control Triple FIM Carrier card or
the Control Triple CIM card (set to dual interface) provides two links
per peripheral bay
n
With a MCC IIIELx control card (installed in a SX-200 ELx cabinet
PN 9109-600-002-NA), the Control Triple FIM Carrier card and the
Control Triple CIM card (set to triple interface) provide three links per
peripheral bay
If you provide
two
links to each bay:
n
Calls must be evenly distributed across all bays
n
Maximum channel blocking ratio is 0.58.
Summary of Contents for SX-200 EL
