Programming
123
Pro
gramming
n
Wink Timer to 100-350 for MCI
and 140-290 for US SPRINT
n
Debounce Timer to 100 ms or greater.
3. To define which information will be displayed on the sets, ANI,
DNIS, both, or none (standard trunk label display), select the
required following COS options:
n
COS Option 502 - Display ANI/DNIS Information = ENABLE /
DISABLE
n
COS Option 613 - Display ANI Information Only = ENABLE /
DISABLE
n
COS Option 503 - Display CLASS Name if required.
4. To display ANI and DNIS digits on a console when talking to an
ANI/DNIS trunk, enable COS Option 502 - Display ANI/DNIS
Information for the console.
Intercept reason (FROM xxx DND) and Forwarding Information (FWD
FROM xxxx) take priority over DNIS.
Tenant Name and Calling Line ID take priority over ANI information
(immediately following the word TRUNK).
COS Option 613 - Display ANI Information Only does not apply to a
console.
The following tables identify displays during each call state according to
digits sent by the trunk and COS options selected for the display set.
If a name is received on the incoming trunk in the scenario
where you would see the DNIS in the ringing state, you will
see the ANI instead.
Summary of Contents for SX-200 EL
