MIOX RIO-S Series Operators Manual
102-00130-D
Page
42
The switch is designed to operate with the RIO-S OSG. To install the level switch in the
tank, complete the following steps:
1. Wrap the male end of the street elbow with Teflon tape and connect it inside the solution
tank into the ½” bulkhead adapter at the top of the tank.
2. Feed the electrical cord through the elbow and out of the tank.
3. Seal the male end of the liquid level switch with Teflon tape and screw it into the female
end of the street elbow. Hand tighten only.
The wire from the level switch is connected to the OSG via one of the external connections
outlined in the External Components/Connections section of the Electrical Overview (Figure
11).
Figure 24: Level Switch Installation
