MIOX RIO-S Series Operators Manual
102-00130-D
Page
21
Figure 7: Main Power to RIO-S OSG
Electrical Power Connection
The power cables to the RIO-S are run through the top of the power cabinet via a large
circular conduit. Route the power cable to the conduit then open the front of the cabinet to
screw in the electrical connections to the top of the breaker and the ground to the buss-bar.
Refer to Figure 7 for additional details.
NOTE: Failure of the system that can be traced to a poor power source is not
covered under the MIOX warranty.
All MIOX systems require a good earth ground. A neutral is not a substitute for an earth
ground. Electrical wiring to all MIOX units should be wired on a separate circuit from
other power devices (pumps, etc.). MIOX cannot be held responsible for systems wired
improperly that do not meet UL or National Electrical Code (NEC) requirements. If the
system is improperly grounded, the MIOX warranty is void. If a local code requires a
GFI (Ground Fault Interrupter) circuit breaker, it is the responsibility of the customer to
install the GFI to meet local code requirements.
Controls Cabinet:
The controls cabinet contains the components of the OSG that handle the operating of the
system and comes completely wired internally from the factory. If needed, refer to Figure 8
for the locations of all major electrical components, and below for a summary of the more
operator-relevant components. If additional clarification is needed, contact your MIOX
Customer Support provider.
Safety
