MIMAKI UJF-605C, Operation Manual

Page: 75 / 154

- 3-7 -
When the waste ink tank becomes full
Waste ink used for cleaning the heads will gather in the waste ink tank.
• Contact your local MIMAKI distributor or call a local MIMAKI office if you
need a spare waste ink tank.
• Prepare a polyethylene tank for emptying waste ink.
• If ink is dripping, wait until it stops dripping.
When the tank is filled with waste ink, the following error message is indicated:
STEPS:
1. Open the waste ink tank box cover.
2. Pull out the waste ink tank while pressing
it downward.
• When pulling out the waste ink tank,
hold the opening of the waste ink
tank with paper and then slowly pull it
out to prevent waste ink from spatter-
ing.
• Before replacing ink, put paper on the
floor to prevent it from being stained
with ink.
3. Dispose waste ink into a separate polyeth-
ylene tank.
• Discard the waste ink according to
the local regulations of the area this
unit is used.
4. Put the empty waste ink tank back into the
device.
Close the Waste ink box cover.
• To avoid hurt hands at the corner of
the tank cover, be careful to set the
tank.
5. Press the [ENTER] key to complete the
procedure.
The device turn to the LOCAL mode.
! INK TANK
WASTE TANK FULL
WASTE TANK
TANK READY :ent
<< LOCAL >>