MIMAKI UJF-605C, Operation Manual

Page: 54 / 154

- 2-16 -
Setting printing origin
When printing in an area not initially set, change the printing origin.
The printing origin can be set in two ways:
• Setting printing origin using jog keys
• Setting printing origin using [ORIGIN] setting from the FUNCTION menu.
Setting printing origin using jog keys
STEPS:
1. Make sure that the LOCAL mode is dis-
played.
2. Move the carriage to the position at which
to establish an origin by pressing the [ ],
[ ], [ ] and [ ] keys.
• Red light pointer mark [
●
] is put on the
table or media. This point becomes the origin
of the coordinates displayed.
3. After deciding the origin, press the [EN-
TER] key.
• The new setting is saved until the origin or
the print area is changed.
• To precisely set the origin, use [ORIGIN]
setting from [FUNCTION] menu .
• Setting the origin by jog keys is cleared when
turning the device off.
<<LOCAL>>
Setting origin position using jog keys
LED pointer mark
Initial origin
New origin
Table
Media
** ORIGIN **
ORIGIN SET
500.0 600.0
Origin position
(front and rear) Origin position
(left and right)