- 6-6 -
Error messages
Error messages indicates error numbers.
If any error message is given on the LCD, turn off the power to the device and turn it on
after a while.
If the same error message appears again on the LCD, contact your local MIMAKI distribu-
tor or MIMAKI office to call for service.
ERROR 01
MAIN ROM
Control circuit board is defective.
Control circuit board is defective.
POWER+5V
POWER+35V
Control circuit board is defective.
The device has received data
other than command data.
The interface cable used is not in
conformance with this printer.
Turn off the power to the device an
turn it on after a while. If the same
error message appears again on
the LCD, contact your local distribu-
tor to call for service.
Securely connect the interface
cable in position. Use an interface
cable in conformance with the
standard.
Error message
Cause
Corrective measure
ERROR 10
COMMAND
ERROR 07
DFC ss
ERROR 06
UHC ss nnnn
ERROR 05
FPGA-ss
ERROR 04
FLASH SAVE
ERROR 03
POWER +35V
ERROR 03
POWER +5V
ERROR 02
MAIN RAM
ERROR 11
PARAMETER
A parameter outside the range of
acceptable numeric values is
received. Strange color data has
been received.
Check the host computer output
setting.
ERROR 12
OFF SCALE
Print the data at outside range.
Check the printing range.
ERROR 13
MEMORY DATA
When each edition has different
resolution or there is the same
color during receiving data in the
MEMORY mode, it is displayed.
In case of copying multi editions,
use the data which has the same
resolution and which there is not the
same color in each edition.
Summary of Contents for UJF-605C
