- 6-2 -
Printing is disabled before the
temperature reaches the predeter-
mined value.
Wait until the temperature
reaches the predetermined value.
When it has reached, the mes-
sage on the display disappears
and printing is enabled.
No
Display [WATER NOT READY] OR [UV NOT READY]
When [WATER NOT READY] appears on the display, the water temperature in the water
heater has not reached the predetermined value. When [UV NOT READY] appears, the
temperature of the UV lamp has not reached the predetermined value; it means the UV
lamp is unavailable and printing is disabled.
Before taking a phenomenon as a sign of failure
Corrective measures against troubles in the case where no error message is given on the
LCD are described in this section. Be sure to take the following measures before taking
the trouble as a sign of failure. If the measures fail restore the device to the normal state,
contact your local MIMAKI distributor or MIMAKI office to call for service.
The device cannot be energized
More often than not, this is due to improper connection of the power cable. Check that the
power cable has been properly connected to the power outlet and the computer.
Has the power cable been con-
nected to the device and the
receptacle?
Securely connect the power
cable to them.
No
Is the correct interface cable
used?
Has the interface cable been
securely connected in position?
Use the cable exclusive for the
device.
Securely connect the interface
cable in position.
No
No
Yes
Replace the ink cartridge with a
new one. (
P. 2-27)
Is the message telling that ink has
run out shown on the display?
The device cannot perform printing
This occurs when the data is not being transmitted to the device properly. It can also occur
when any of the device functions fails or the media has been set improperly.
Yes
Summary of Contents for UJF-605C
