- 2-13 -
Checking head gap
When continue mode has been selected, be sure to check the gap. The table can be ad-
justed in height, according to thickness of a media used for printing. The table height must
be set according to the media thickness. If the table height is too low, it may affect the
printing quality and even damage the media or the device itself. Be sure that the table
height is correct.
• When Continue mode has been selected
The head gap adjustment is performed once during printing after turning on
the main power or initializing the data. Make sure to adjust the head gap
for the gap check is not performed when the media thickness has been
changed.
STEPS:
1.
Make sure that the LOCAL mode is dis-
played after setting media.
2.
Press the [FUNCTION] key three times.
3.
Press the [ENTER] key.
4.
Select [CHECK START], then press the
[ENTER] key.
When the table isn't at the lowest position, display
the right message and move the table to the
lowest position.
5.
Set the media on the table.
6.
After setting the media, press the [ENTER]
key.
Automatically starting the vacuum on when the
vacuum switch is off.
7.
Press the [ ] key to move the table until
the tail of media reaches the end of the
front cover.
<<LOCAL>>
GAP CHECK
SET MEDIA
:ent
** TABLE FALL**
PLEASE WAIT
GAP CHECK
CHECK START
<ent>
FUNCTION
GAP CHECK
<ENT>
3 TIMES
GAP CHECK
MOVE TABLE
:ent
Summary of Contents for UJF-605C
