MIMAKI UJF-605C, Operation Manual

Page: 16 / 154

- xiv -
Precautions in use
CAUTION
Warning labels
• This device is adhered with a
warning label. Be sure understand
firmly the warnings given on the
labels. In the case where any of the
warning label has become so soiled
that the warning message is illegible
or has come off, purchase a new
one from your local distributor or our
office. Refer to Appendix for the
label
Ink cartridges
• If the ink cartridge is moved from a
cold place to a warm place, leave it
in the room temperature for three
hours or more before using it.
• Open the ink cartridge just before
installing it in the printer. If it is
opened and left for an extended
period of time, normal printing
performance of the printer may not
be ensured.
• Make sure to store ink cartridges in
a cold and dark place.
• Be sure to thoroughly consume the
ink in the ink cartridge after opened.
If an extended period of time has
passed away after opening the
cartridge tank, printing quality would
be poor.
• You cannot use any other ink type
than the exclusive one. If you use
any other ink type, it may cause the
damage for the device.
To repair of the device is your
responsibility as used instead the
exclusive one.
• Never refill the ink cartridge with ink.
• Neither pound the ink cartridge nor
shake it violently so as to prevent
leakage of ink adhering locations.
Periodic exchange parts
• There are some parts which must be
replaced by service men. You have
to make a contract with distributors or
dealers for after-sale service.
Protection against dust
• It is strongly recommended to use
the device in a room that is not dusty.
Set the Refresh level 2 or 3 when in
bad environment.
• When leaving the workshop after the
working hours, be sure to take off
any media from the roll hanger. If any
media is left on the roll hanger, dust
can put on it.
• Store media in a bag. Wiping off dust
accumulated on a media will
adversely affect the media due to
static electricity.
• Frequently the capping station clean
to eliminate dust and paper chips.
• Dust in the head will also cause
drops of ink to fall abruptly down on
the media during printing. If this
phenomenon takes place, be sure to
clean up the head.
Cover
• Never open the cover during printing.
Opening the cover or lever will abort
printing.
Adjusting the level
• The level must be adjusted before
printing can start.
Handling of maintenance liquid
• Be sure to store the maintenance
liquid in a cold and dark place.
• Store the maintenance liquid in a
place that is out of the reach of
children.