50 / 72
HBC-series V7 LV+MV
to USB port in PC
CC_11
Connection cable
CC_11
Connect to
ICS-2
connector
ICS-2
Parameters setting / Data reading from controller
To set parameters or reading data from the controller,
you need to
connect your PC and the controller module
USBCOM 4
or
USBCOM 4i
(for the controller feeding from the mains power supply), the PC software
"
Controller 2
", which is free to download from our web and on CD and
need connecting cable
CC_11
.
1)
start program
Controller 2
2)
connect
USBCOM 4(i)
module to USB port of your PC and connect with controller by
CC_11
cable (cable
CC_11
is connected to
ICS-2
marking connectors, in both equipment)
3)
turn on controller by connect to suitable battery (and turn-on switch for version with switch)
4)
now you can communicate with controller, read data, change parameters value, write changes parameters etc.
Don´t forget select memory bank first, change parameters after this. Before switch-off write parameters by button “
Write setting
.
Important:
If the controller is feed from the battery, module
USBCOM 4
is enough to connect of the controller to the PC. But if you
nned use power supply for feeding the controller, you must use module
USBCOM 4i
, which ensure galvanic isolation of
the controller from the PC. This is necessary because a number of mains power supply (either in PC or others) is not ful-
ly correct separated from their chassis (minus their potentials, GND) and is possible measured frequently large voltage
(units to tens of volts). If you apply in this case USBCOM 4 unisolated module, you risk damaging or destruction as
USBCOM 4 module, as well as also the controller (or USB port on your PC).
Program Window
in the PC screen:
S
h
if
t
to
o
th
e
r
p
a
ra
me
te
rs
h
idd
e
n
b
e
low
a
n
d
u
p
controller type and
version
Language select
Main control
Parameter value
set as number
Select from
possibilities
parameters
setting area
„Analog“
value setting
