Information on the roof luggage rack
&
WARNING Risk of injury if maximum roof
load is exceeded
The vehicle center of gravity and the usual driv-
ing characteristics as well as the steering and
braking characteristics will change.
If you exceed the maximum roof load, the driv-
ing characteristics, as well as the steering and
braking characteristics, will be greatly
impaired.
#
Always comply with the maximum roof
load and adjust your driving style.
*
NOTE Vehicle damage due to failure to
observe the maximum permissible clear-
ance height
If the vehicle height is greater than the maxi-
mum permitted clearance height, the roof and
other parts of the vehicle may be damaged.
#
Observe the signposted clearance
height.
#
If the vehicle height is greater than the
clearance height, do not enter.
#
Note the changed vehicle height with
roof mountings.
1
Mounting rails
Information about the maximum roof load can be
found in the "Technical data" section
(
/
page 299).
Observe the following points for installing roof lug-
gage racks:
R
Tighten the screws of the roof luggage rack to
a torque of 6.0 lb-ft (8 Nm) – 7.4 lb-ft (10 Nm)
in the designated sliding blocks.
R
The tightened screws should not touch the
rails.
R
Ensure that the sliding blocks are not located
in the areas around the plastic caps.
R
The sliding blocks must have the right cross-
section.
R
The insides of the mounting rails must be free
of dirt.
R
Re-tighten the screws uniformly after around
300 miles (500 km).
Mercedes-Benz recommends that you use only
roof luggage racks that have been tested and
approved for Mercedes-Benz. These help to pre-
vent vehicle damage.
Have mounting rails retrofitted only at a qualified
specialist workshop. Otherwise, you could damage
the vehicle.
If your vehicle is equipped with mounting rails on
the roof, you can install a roof luggage rack on the
roof. Special fasteners (sliding blocks) are available
as accessories for this purpose.
These fasteners are available from any authorized
Mercedes-Benz Center.
Placing a load on the wheel arch
Comply with the important safety notes under
"Notes on loading" (
/
page 207).
#
Place the objects on wheel arch
2
and lash
them using tie-down eyes
1
(
/
page 209).
210 Transporting
