Setting the hot-water auxiliary heater using the
Requirements:
R
The fuel tank is filled above the reserve level.
R
The vehicle is switched on.
On-board computer:
4
Settings
5
Heating
Setting the switch-on time
#
Select
Settings
.
#
Select the desired departure time.
Activating the departure time
#
Activate the departure time by ticking the box.
%
Ensure that A, B and C each correspond to a
programmed departure time.
%
The programmed time will remain set only until
the next time the vehicle is started.
Selecting a programmed time
#
Set the required programmed time – A, B or C.
%
The required programmed time – A, B or C –
will appear only if the box to activate the
departure time is ticked.
#
Select the required programmed time by swip-
ing left or right, e.g. A, B or C.
Rectifying problems with the hot-water auxiliary
FAIL
¨
appears on the remote control display
Possible cause:
R
Signal transmission between transmitter and
receiver is malfunctioning.
#
Change your position in relation to the vehicle,
moving closer if necessary.
FAIL appears on the remote control display
Possible cause:
R
The starter battery is not sufficiently charged.
#
Charge the starter battery.
Possible cause:
R
The fuel tank is not filled up to the reserve
level.
#
Refuel at the nearest gas station.
FAIL appears on the remote control display
¯
Possible cause:
R
The auxiliary heating has malfunctioned.
#
Have the auxiliary heating checked at a quali-
fied specialist workshop.
Operating cargo compartment ventilation
If your vehicle is equipped with a roof ventilator,
you can admit fresh air to the cargo compartment,
or extract air from it as well.
#
Switch on the vehicle.
#
To switch on and extract: press switch
1
at
the top.
The roof ventilator will remove used air from
the cargo compartment.
#
To switch on and admit fresh air: press switch
2
at the bottom.
The roof ventilator will feed fresh air into the
cargo compartment.
#
To switch off: place the switch in the center
position.
Climate control 107
