Mercedes-Benz 2006 C 230 Sport, Operator'S Manual

Page: 276 / 474

275
Controls in detail
Useful features
Step 3:
왘
Hold the end of the hand-held remote
control
5
of the device you wish to
train approximately 2 to 5 in (5
to12 cm) away from the signal trans-
mitter button (
2
,
3
or
4
) to be pro-
grammed, while keeping the indicator
lamp
1
in view.
Step 4:
왘
Using both hands, simultaneously
press the hand-held remote control
button
6
and the desired signal trans-
mitter button (
2
,
3
or
4
). Do not
release the buttons until step 5 is com-
pleted.
The indicator lamp
1
will flash, first
slowly and then rapidly.
Step 5:
왘
After the indicator lamp
1
changes
from a slow to a rapidly flashing light,
release the hand-held remote control
button and the signal transmitter but-
ton.
Step 6:
왘
Press and hold the just-trained signal
transmitter button (
2
,
3
or
4
) and
observe the indicator lamp
1
.
If the indicator lamp
1
stays on
constantly, programming is complete
and your device should activate when
the respective signal transmitter
button (
2
,
3
or
4
) is pressed and re-
leased.
i
The indicator lamp
1
flashes immedi-
ately the first time the signal transmit-
ter button is programmed. If this button
has already been programmed, the in-
dicator lamp will only start flashing af-
ter 20 seconds.
i
If the indicator lamp
1
flashes rapidly
for about 2 seconds and then turns to a
constant light, continue with
programming steps 8 through 12 as
your garage door opener may be
equipped with the “rolling code”
feature.
컄컄