77
7.25 Inlet / Outlet Manifold Valve Harness
Tools and Supplies Required:
5/32" hex key
9/16”
wrench
7/16”
wrench
1. Remove the rear panel per Section 7.3.
2.
Note:
Observe the routing of the cable to the Input/Output
circuit card. Ensure that wires are not pinched when
reassembling.
Inlet / Outlet Manifold
Figure 7.30
3.
Lift the lever on the Circulating Pump (located below the
manifold) then remove the connector from the pump.
Removing Pump Port
Figure 7.31
4. Pull the Inlet /Outlet manifold forward then down to slide it off
the chassis.
5. Unplug the pressure transducer plug from the green circuit
board by first compressing the tab on the underside of the
connector. Do not stress the wires.
Removing Plug
Figure 7.32
Summary of Contents for Arctic Sun 2000
Page 2: ......
Page 10: ...6 Blank Page...
Page 20: ...16 Blank Page...
Page 80: ...76 blank page...
