Medivance Arctic Sun 2000, Service Manual

Page: 67 / 85

63
7.4 Side Panels
Tools and Supplies Required:
ƒ
5/32” hex key
1. Remove the rear panel per Section 7.3.
2. Remove the front grill per Section 7.2.
3. Remove the two screws located on the underside of one side
panel with a 5/32” hex key.
4. Hold the panel on both sides and move it towards the rear of
the unit. Slide the panel out from front to back. There are four
key slots which accept white plastic key nuts.
5. Repeat this process for the other side panel.
6. To replace the side panels, align the white key nuts horizontally,
rotated to allow the threaded stud to engage the slots in the
frame.
Side Panel Screw Removal
Figure 7.8
7.5 Card Cage
Tools and Supplies Required:
ƒ 5/64” hex key
ƒ 5/16” nut driver
Note:
Observe electrostatic discharge control procedures when
handling circuit cards.
1. Remove the rear panel per Section 7.3
2. Remove right side panel Section 7.4.
3. Through the right side of the frame, disconnect the wire which
connects to the rear of the card cage.
4. Disconnect the (heater) cable from under the card cage.
Chiller Power Wire Harness
Figure 7.9
Heater Wire Harness
Figure 7.10