Medivance Arctic Sun 2000, Service Manual

Page: 18 / 85

14
Remote Display Cable and Clamp Rear
View
Figure 3.2
Strain Relief
Figure 3.3
3.1 Installation of Cables and Accessories
1. Unpack the Model 2000 and accessories.
2. Adjust the Control Module handle to a vertical position and secure
by tightening the knobs on both sides.
3. Connect the Remote Display Cable to the back of the Remote
Display. Install the Remote Display clamp onto the handle. Route
the cable through the three clips on the side of the handle.
Connect the Remote Display Cable connector at the labeled
location on rear panel of the Control Module.
4. Insert the Patient Temperature Cable into the labeled location on
the rear panel of the Control Module.
5. Insert the optional Patient Temperature #2 Cable into the labeled
location on the rear panel of the Control Module.
6. Insert the optional Patient Temperature Out Cable into the labeled
location on the rear panel of the Control Module.
7. Using the clips and wing nuts from the Strain Relief Kit, anchor the
cables to the back panel.
8. Move the latch of the fluid In/Out Manifold to the left. Connect the
Fluid Delivery Line to the Inlet/Outlet Manifold. Move the latch on
the manifold to the right to lock it in place.
9. Gently push the fitting of the fill line into the fill port. Secure the line
to the rear panel as shown in the picture.
Fill Line
Figure 3.4