19
Removing Front Grill
Figure 4.4
4.5
Clean the Condenser
The Arctic Sun condenser fins should be inspected for dirt and
debris every three months or more often with heavy use or dusty
environment. The condenser is located underneath the grill on the
front of the control module.
1. Remove the front grill by pulling the bottom out, then using
both hands at the top of the panel pull it straight out and away
from the control module. For maximum performance, the
condenser fins should be free of dust and debris.
2. Use a brush or vacuum to remove any dust or debris.
Condenser
Figure 4.5
4.6
Replace the Filter
Tools and Supplies Required:
5/16” hex key from the Arctic Sun Maintenance Kit.
Filter from the Arctic Sun Maintenance Kit
1. Remove the Fluid Delivery Line from the Inlet/Outlet Manifold.
2. Insert the wrench into the left fitting of the manifold. Unthread
the fitting and slide out.
3. Remove the screen filter and discard.
4. Slide the fitting, then the filter over the wrench and seat the
filter into the fitting.
5. Insert the wrench into the manifold until it stops.
6. With your fingers push the fitting into the manifold and
carefully rotate the wrench to thread the fitting into the
manifold. Do not over tighten.
Manifold Inlet Filter and Fitting
Figure 4.6
Summary of Contents for Arctic Sun 2000
Page 2: ......
Page 10: ...6 Blank Page...
Page 20: ...16 Blank Page...
Page 80: ...76 blank page...
