Maytag Commercial MYR20, Service Manual

Page: 65 / 88

4-41
1. To remove the bearing housing, remove the
back panel (See page 4-36).
2. Remove the 15mm bolt securing the basket
pulley to the center of the basket shaft.
There is a flat washer on the bolt.
3. Pull the basket pulley off the shaft.
4. Remove two T-20 screws securing the
speed sensor bracket to the bearing
housing (See page 4-39).
5. Cut the wire tie, securing the speed
sensor wire harness, and move the sensor
assembly out of the way.
6. At the front of the washer, insert wedges
between the inner basket and the tub cover
at the 10,2, and 6 O’clock positions.
7. Install a clamp at each wedge position to
secure the front of the spin basket in place.
8. Eight bolts secure the bearing housing to
the tub support. The empty holes visible at
the left and right of the bearing housing are
for use with jack bolts.
9. Remove the bearing housing bolts. There is
no particular order to the removal process.
10. One method to remove the bearing
housing is using jack bolts. Thread a
jack bolt into the hole on each side of the
bearing housing. Hand tighten these bolts to
start.
11. Tighten the jack bolts evenly, alternating
from side to side, until the bearing housing
is pushed off the shaft.
Electrical Shock Hazard
Disconnect power before servicing.
Failure to do so can result in death or
electrical shock.
Replace all parts and panels before
operating.
BearinG HOuSinG
15mm Hex
Head Bolt
Jack Bolt
Hole
Jack Bolt
Hole