11.0
SCREEN DEFINITIONS, ALPHABETICAL LIST
www.maxcessintl.com
MAGPOWR Spyder-Plus-S1 Tension Control
MI 850A351 1 C
Page 56 of 68
Taper Percent
From the
Operator Loop
.
When REWIND or UNWIND type is selected, you may enter a value
here that will taper off the output as the roll progresses from core to
full. This feature is useful for reducing the inward forces that develop
in rolls with a large differential between core and full diameters. If you
are experiencing crushed cores, telescoping or starring rolls, try
increasing taper in steps until you reach a value that works well for
your process. See Section 6.2.1.3 or 8.2.1.4.
Taper Setup
One of the top level menu screens. Used to calibrate diameter and to
edit Core Diameter and Full Roll Diameter.
Tension
In the
Operator Loop
.
Displays the actual tension in both numeric and bar graph forms.
Try larger Max
From the
Cal Sensors
menu.
The Spyder will suggest a Max Tension that will make sure that the
load cells are loaded to at least 1/8 of their Maximum Tension. This
may mean that a load cell with too large of a rating has been
installed.
Try smaller Max
From the
Cal Sensors
menu.
The Spyder will suggest a Max Tension that will keep the load cells
from being out of range at Max Tension
Tune I First. Then P second
From the
Tuning
menu for point to point systems.
The Spyder should be optimized in the order shown.
Tuning
One of the top level menu screens. Used to optimize the dynamic
tuning of the system.
Unload sensing roll.
From the
Cal Sensors
menu.
Load cell calibration happens in two steps. In this first step all loading
must be removed from the sensing roll mounted on the load cells so
that the roll weight can be zeroed out.
Use Diameter
From the
Configure
menu.
In load cell mode, selects either Estimated or Voltage diameter.
In Dancer mode, selects whether diameter is used in the control (gain
compensated dancer).
Use DHCP
From the
Network
menu.
Determines if the Spyder will try to get a dynamic IP address from a
DHCP server. If
NO
is selected, IP Address, Gateway Address and
Subnet Mask must be configured.
Use Inertia Comp
From the
Configure
menu.
Select “Yes” to enable inertia compensation during the stop time.
Summary of Contents for MAGPOWR Spyder-Plus-S1
Page 2: ......
