9.0 OPTIONAL FUNCTIONS
www.maxcessintl.com
MAGPOWR Spyder-Plus-S1 Tension Control
MI 850A351 1 C
Page 39 of 68
9.1 PREFERENCES MENU
This section describes all the screens in the Preferences menu.
Navigate to the
Preferences
menu and Press
.
9.1.1
LANGUAGE
Select the language.
9.1.2
TENSION UNITS (Load cell systems and Dancer systems with Load Cells Enabled)
Select the Tension Units. For load cells using inertia, sets the units for the core inertia parameter in the Inertia
Setup menu.
9.1.3
DISTANCE UNITS
Select the Distance units.
9.1.4
VELOCITY UNITS (Load cell only)
Select the Velocity units.
9.2 TAPER TENSION SETUP
This section describes all the screens in the Taper menu.
Taper Tension is the reduction of tension as the diameter increases on a
rewind. Taper Tension is desired on rewinds to prevent crushed cores and
telescoping rolls caused by excess tension build up.
9.2.1 Taper with Load Cell Control
Diameter is estimated or read from a voltage input proportional to diameter
and must be calibrated to use taper tension.
Taper Percent, Section 6.2.1.3 must be set to
0
(zero) to calibrate taper.
Navigate to the
Taper Setup
menu and Press
.
Select
Yes
to enable Taper. Press
.
Enter the core diameter. The operator sets the setpoint tension only at core.
The tension at all diameters greater than core is less than the Core Tension.
Press
when finished.
Enter the diameter of the full roll. The Core Tension and Percent Taper
determine the tension at the full roll diameter. Press
when finished.
If diameter is Voltage, go to the Calibrate Diameter menu screen to calibrate
diameter. If diameter is Estimated, use the next three screens to calibrate the
present diameter.
For Estimated Diameter:
The Present Diameter screen actively displays the diameter as estimated by
the Spyder when in Run mode. Press
to calibrate taper.
Select
Yes
and press
to enter the Present Diameter. This screen defaults
to
No
and helps prevent accidentally overwriting a previous calibration. Taper
Percent (Section 6.2.1.3) must be set to
0
(zero) to calibrate taper.
Enter the present diameter. This should be the present diameter of the roll.
The Spyder must be in Run mode. Press
to finish the calibration.
Summary of Contents for MAGPOWR Spyder-Plus-S1
Page 2: ......
