Marvelmind IA-04-2D-Badge, Operating Manual

Page: 87 / 263

87
6.3.19. Connect the modem/router via USB to a Windows PC with the Dashboard
installed
6.3.20. Run the Dashboard. In the left corner of the Dashboard, the modem should
be shown as connected
6.3.21. Wake up all beacons by selecting them on the Dashboard panel
Only 4 stationary beacons may be in 1 submap. If you wake up more beacons,
create new submap for
them or it won’t be displayed on the map and in the table
of distances.
6.3.22. It may take up to 7-10 seconds for the beacons to wake up
6.3.23. Notice, that if the modem is not active and is not powered, the beacons will
go into sleep mode automatically after 1 minute
6.3.24. The system may run the frequency search, if it is the very first time you are
waking up the beacons. If this step does not work, disconnect the modem and
connect that beacon again via USB. Press the DEFAULT button in the
Dashboard and the Read All button to make sure that the radio settings are the
default ones
6.3.25. Check that the radio settings on the modem and the radio settings on the
beacon are the same
6.3.26. Now you can check RSSI, voltage, ultrasonic filter settings, etc. on the
panel on the right corner of the Dashboard