Marvelmind IA-04-2D-Badge, Operating Manual

Page: 110 / 263

110
-
Run the Dashboard and update the SW for all beacons and modem using Dashboard =>
Firmware => Choose the file => Program
-
If you see the message “Not found modem connection to computer through USB” in the
Dashboard or your PC does not recognize beacons/modem, it usually means that the
STM32 driver is not installed. To install the driver, download it with link at top window in the
Dashboard and run the installation file, then click on the link under and install the driver
Ensure that:
-
You are programming the
modem’s SW to the modem and the beacon’s SW to the beacon
-
You are using SW for 4.9, if you have HW v4.9; and you have the SW from the same SW
pack, i.e., the Dashboard SW, modem SW, and beacon SW must be from the same SW
pack. Don’t mix SW releases
If SW flashed SUCCESSFULLY, MOVE DIRECTLY TO 4.6.6. If you have some
problems with HEX programming, use DFU programming:
DFU programming or SW uploading is used when HEX SW uploading in the Dashboard
cannot be used. For example, when you are updating from a very old SW version or when
the SW includes major changes to the system and the only possible way to update the SW
is via DFU programming
-
After the DFU SW upgrade, futures SW upgrades can be done in a regular manner
via the Dashboard
-
Industrial beacons have magnetic DFU mode and reset
-
Download the latest SW package , unzip it, and select the proper version of the SW for
your HW and for your frequency variant. Remember that for DFU programming, you
should use DFU SW (DfuSe), not Da
shboard’s .hex file
Magnetic DFU switch side Magnetic Reset side