Physical installation
15
2. Fold the yoke around to the bottom of the fixture (the side with the heat exchanger if
the luminaire will stand on the yoke, or the side without the heat exchanger if the
luminaire will hang from the yoke)
3. Slide the yoke forwards until the edge of the yoke lines up with the mark (arrowed) on
the label on the side of the luminaire. In this position, the edge of the yoke is 400 mm
(15 ¾ in.) from the end of the luminaire and the luminaire’s weight is balanced in the
yoke.
4. Tighten the yoke clamp locking screws and tilt lock screws to 16 Nm (11.8 ft.-lbs.)
.
Installing the lamp and removing protective packaging
See Figure 2. Before the Exterior 1200 Image Projector can be used, you must open it,
remove the shipping bracket (
A
) from the lenses and protective foam insert (
B
) from
around the CMY flags, and then install the lamp supplied with the product. It will almost
certainly be easiest if you do this now, before the luminaire is installed in its final location.
Important! Keep the shipping bracket and foam insert for future use and install them
if you ever need to transport the luminaire.
See "
8.5.3: Installing the lamp"
on page 64 for instructions on opening the luminaire and
installing the lamp.
3 . 1 . 2 L o c a t i o n a n d m o u n t i n g
Lifting
DANGER! Use only the lifting eyebolts provided to lift the luminaire. Eyebolts must
be securely installed with washers at all four corners of the luminaire as illustrated
below.
See Figure 3. The Exterior 1200 Image Projector is supplied with four eyebolts for lifting
purposes during installation or service. Do not use any other method to lift the luminaire.
The eyebolts screw into blocks in the yoke slider channels on each side of the fixture. Use
the supplied washers to avoid damage to the luminaire housing. Make sure that eyebolts
Figure 2: Protective packaging – remove before use!
A
B
Summary of Contents for Exterior 1200
