![background image](http://html1.mh-extra.com/html/martin/exterior-1200/exterior-1200_user-manual_1732848058.webp)
58
Exterior 1200 Image Projector user manual
8.1 Service: general
DANGER! Read "
Safety information"
on page 4 before servicing the Exterior 1200
Image Projector.
Important! The Exterior 1200 Image Projector requires regular service and
maintenance to maintain reliable operation and protect the investment it represents.
Before servicing, switch off the lamp via DMX or the onboard control panel and
allow the luminaire to cool with fans running for 20 minutes before powering off.
If you ever need to transport an Exterior 1200 Image Projector, reinstall the shipping
bracket and protective foam insert supplied with the product (see Figure 2 on page
15).
The service and maintenance procedures described in this section must be carried out by
qualified professionals only. Any service procedures not described in this section must be
carried out by the Martin Service organization or its authorized agents.
Martin uses the best-quality materials and coatings available to ensure optimum
performance and the longest possible component lifetimes. However, optical components
in all luminaires are subject to wear and tear over the life of the fixture, resulting in gradual
changes in color rendition of dichroic filters or the specular properties of reflectors, for
example. The extent of wear and tear depends heavily on operating conditions,
maintenance and environment, so it is impossible to specify precise lifetimes for optical
components. However, you will eventually need to replace optical components if their
characteristics are affected by wear and tear after an extended period of use and if you
require luminaires to perform within very precise optical and color parameters.
8.2 Beam adjustment
The beam can be adjusted in a vertical
plane (tilt) using the tilt lock on the yoke.
The beam can be adjusted in a horizontal
plane (pan or rotation) using the curved
slots in the yoke base.
To adjust tilt:
1. Support the luminaire to ensure that it
cannot tilt unexpectedly under its own
weight. See Figure 16. Loosen the tilt
lock screws on each side of the
mounting yoke.
2. Tilt the luminaire to the desired angle in
the yoke and retighten the screws to a
torque of 16 Nm (11.8 ft.-lbs.).
To adjust pan:
1. Loosen the anchor bolts in the yoke base slightly so that the luminaire can be rotated.
2. Adjust the pan position and retighten the bolts.
Figure 16: Tilt lock screws
Summary of Contents for Exterior 1200
