Quick Start Reference Sheet
Sharp XG-C45XU
Revision A
DR-SHP22 - 12/18/03
SP Controls reserves the right to modify specifications without notice at any time.
NOTE:
This one-page document is intended
only as a quick reference for installation
– please read
the SP Controls Application Note for a complete description of this projector driver prior to installation.
I. Driver Features
1. Input Selection Mapping
Selection 1:
VIDEO
Selection 2:
S-VIDEO
Selection 3:
RGB 1
Selection 4:
RGB 2
2. Hidden Function Mapping (Default Configuration)
Using the ON button as a shift key, press the following buttons to access the specified projector features.
Selection 1:
BLANK SCREEN
Selection 2:
ENTER
Selection 3:
ADJ LEFT
Selection 4:
ADJ RIGHT
Off:
MENU
Volume Up:
ADJ UP
Volume Down:
ADJ DOWN
3. Other Driver Features
Power Status Feedback Method
RS-232 Power Polling
Control Wiring:
RS-232 and IR-Emitter
II. Wiring Specifications
NOTE: For a wiring diagram, please see the SP Controls Application Note.
1. RS-232:
Wire the Panel RS-232 port to a female DB9 as follows:
TX to
2
RX to
3
GND to
5
Connect this female DB9 to the included Sharp intermediate cable (labeled RS-232C) and connect
the mini-DIN end of the adapter to the projector port labeled
CONTROL
.
2. Infrared Emitter:
Wire the Panel IR/Serial port to a female 1/8" Mini as follows:
IR/SER
to
tip
GND
to
ring
Connect to the included IR Emitter and attach the emitter bud to any projector IR window.
III. Additional Projector Information
The C45XU can be configured with an
Economy Mode
, which determines whether or not the projector
shuts itself off in the absence of an input signal.
When installing the C45XU,
you should set the Economy Mode to OFF
.
This disables the Sharp’s
Automatic Power Shutoff
feature.
Economy Mode is set via on screen menus,
Options: Economy Mode.
Access the onscreen menus with
either the SmartPanel’s hidden functions, or the Sharp’s remote control.
