Lamp maintenance
65
3. See Figure 19. Pull out
the slider locks in the
sliders on each side at
the front of the housing
and slide the lamp/effects
assembly out of the
housing, avoiding strain
on internal wiring. Note
that a lamp cutout
mechanism is activated
as soon as the assembly
is moved from its normal
position.
4. See Figure 20. Flip open the latch plate to lock the assembly in the out position.
5. See Figure 21. The lampholder is
at the rear of the effects modules.
Note the position of wiring to the
lamp. Loosen, but do not remove,
the three Allen screws (arrowed)
holding the lampholder. To
release the lampholder, push it in
slightly and rotate it so that the
holes in the lampholder plate
clear the Allen screws, then gently
pull the lampholder clear. Avoid
touching or knocking the lamp
against other components.
Figure 19: Slider lock
Figure 20: Slider latch plate
Figure 21: Lampholder screws
Summary of Contents for Exterior 1200
