34
Exterior 1200 Image Projector user manual
5.1 Luminaire settings
This section describes how to set up luminaires for either:
• single fixture stand-alone operation, in which individual luminaires run programmed light
shows independently,
• synchronized stand-alone operation, in which one master luminaire sends signals to
slave luminaires on a data link so that light shows are synchronized, or
• DMX operation, in which luminaires on a data link are controlled remotely using a DMX
control device.
There are three ways to set up luminaires:
MUM (Multi-
Utility
Manager)
The Martin MUM (Multi-Utility Manager) is a PC software
application available from Martin Architectural in a set
(P/N 90758090) that also includes a DABS1 interface
adaptor and suitable cables. The set allows a PC to be
connected to a luminaire via a data link or RJ-45 service
socket.
We recommend MUM because it provides an intuitive,
easy-to-use, graphical user interface.
Note that MUM can only be connected to, and set up,
one luminaire at a time.
Setup using MUM is described in "
5.1.1: Setting up a
luminaire with a PC and MUM"
on page 35.
Martin MP-2
Uploader
The Martin MP-2 Uploader is no longer available from
Martin Architectural, as its text-based interface has been
superseded by MUM.
However, the MP-2 is still supported, so if you wish to
use it to upload software or apply settings to the Exterior
1200 Image Projector, see the separate
Guide to Using
the MP-2 with the Exterior 1200 Series
, available from
the Support page for the Exterior 1200 Image Projector
on the Martin Architectural website at
http://www.martin-architectural.com
Onboard
control
panel
The onboard control panel is a convenient way of
configuring a luminaire with no external equipment, but
access to the luminaire is required.
Setup using the control panel is described in "
5.1.2:
Setting up a luminaire with the onboard control panel"
on
page 37.
Summary of Contents for Exterior 1200
