68
Exterior 1200 Image Projector user manual
8.7 Installing a filter in the color wheel
Filters (including CTC filters and a diffuser filter) for the color wheel can be ordered from
Martin Architectural if custom configuration is required. Note that the diffuser filter does
not affect the beam angle but causes a slight reduction in luminous output.
Filters must be perfectly clean and free of grease when installed. Wear clean cotton
gloves so that you can manipulate filters without contaminating them with oil from your
fingers. If necessary, clean filters with a soft lint-free cloth wetted with 99.9% isopropyl
alcohol.
To install a filter in the color wheel:
1. Lock out power, open the luminaire and slide the effects module out of the housing as
described in "
8.5.3: Installing the lamp"
on page 64.
2. See Figure 24. Access the color filters (
C
) from underneath the effects module. Rotate
the color wheel with your fingers until the position where you want to install the filter is
pointing downwards in the wheel.
3. To remove a filter, gently lever the filter retaining spring (
A
) away from the color wheel
(
B
), lift the filter (
C
) away from the color wheel so that it clears the retaining lugs (
D
),
and lift the filter out of the wheel.
4. To install a filter on the color wheel, gently lever the retaining clip (
A
) away from the
wheel and slide the filter in under the clip until it locates in the retaining lugs (
D
).
Release the clip so that it holds the filter. Grasp the filter on both sides and check that
it is held securely.
5. Slide the effects module back into the luminaire housing and close the luminaire as
described in "
8.5.3: Installing the lamp"
on page 64 before reapplying power.
Figure 24: Color filter replacement
A
B
C
C
D
D
D
Summary of Contents for Exterior 1200
