![background image](http://html1.mh-extra.com/html/martin/exterior-1200/exterior-1200_user-manual_1732848028.webp)
28
Exterior 1200 Image Projector user manual
4.1 General
DANGER! Read "
Safety information"
on page 4 before applying power to the
Exterior 1200 Image Projector.
This section contains general information about the features and functions as well as
basic programming and operating principles of the Exterior 1200 Image Projector. Read
this section to familiarize yourself with the luminaire before attempting to program or
operate it.
Important! Leave the luminaire powered on permanently except during service.
4 . 1 . 1 P o w e r i n g o n
When the luminaire is connected to power for the first time, it will start running a factory-
set light show to test the fixture. It will continue to run this test show until a new show is
programmed into it, or until it receives DMX commands.
When the luminaire is powered on in normal use, the luminaire software version appears
in its display, runs an internal test and resets all effects to start positions. It must complete
this reset before it can respond to DMX commands or run a stand-alone show.
4 . 1 . 2 M a i n t a i n i n g p o w e r a n d t e m p e r a t u r e
r e g u l a t i o n
Except during service, maintain power to the luminaire permanently even when the lamp
is not lit.
In hot environments, this will allow the cooling system to regulate the luminaire’s internal
temperature at all times. Heat damage resulting from failure to maintain power is not
covered by the product warranty.
In cold environments, the internal heat generated will keep electronics warm and ensure
satisfactory performance at ambient temperatures as low as -20° C (-4° F). Note that if the
temperature inside the luminaire falls below -10° C (14° F), effects are disabled and the
dimmer is closed until the internal temperature rises above this level again.
4 . 1 . 3 P o w e r i n g o f f
Important! Leave power applied for 8 minutes after switching off the lamp.
If the lamp is lit and you wish to cut power (for service, for example), you must first switch
off the lamp via DMX or the onboard control panel and wait at least 8 minutes before you
cut power. This will give cooling fans enough time to reduce the luminaire’s temperature
and avoid heat damage. Damage caused by failure to follow this procedure is not covered
by the product warranty.
Summary of Contents for Exterior 1200
